How to Stay Warm Riding a Motorcycle in Winter

Motorcycle rider on a loaded adventure bike on a gravel road in cold weather, bare winter trees behind

Cold on a motorcycle isn't the same as cold standing in the driveway. You can feel fine pulling out of the garage and be shivering twenty minutes later on the highway. The difference is wind. At 60 mph, moving air pulls heat away from you much faster than still air does, and it finds every gap in your gear.

So when riders ask us how to stay warm in winter, our answer always starts in the same place: stop the wind first, then add warmth underneath, and know the point where clothing alone isn't enough anymore.

Start with your temperature range

Before you buy anything, figure out how cold and how fast you actually ride. A couple of hours on back roads in the low 50s is a very different problem from a 90-minute highway commute at 38°F.

Here's my rule after years of riding and testing gear: when I'm riding highway speeds for longer than about 30 minutes and it's below 45°F, I need heated gear.

I've tried the alternatives. I've ridden the Tourmaster Mariner into the high 40s and had to stop about every 30 minutes to warm back up at speed. On slower gravel roads and trails, the same gear was fine. And I haven't found a shell and mid-layer combination that keeps me warm below 45°F at a steady 60 mph or faster. Even my Klim Gore-Tex gear with a puffy jacket underneath topped out around 45°F.

Standing in the snow next to my adventure motorcycle on a cold-weather ride

Your number may be a little higher or lower. Everyone runs differently, and every bike's wind protection is different. But that gives you a realistic starting point.

Wind is the real enemy, so the shell comes first

Here's where a lot of winter setups go wrong. A rider takes a regular vented textile jacket, stacks two hoodies under it, and wonders why they're still cold. If air can push through the outer layer, it strips away the warm air your layers are trying to hold, no matter how many you add.

That's why a windproof or Gore-Tex shell has a real edge over a standard textile jacket plus a pile of layers. The membrane stops air from blowing through, so the warmth you build up underneath stays with you. It also keeps rain and road spray out, and being wet is the fastest way to get cold.

What we'd look at:

  • Klim Carlsbad and Latitude: the big two. These are the big, popular Gore-Tex suits, and they're where I'd start. The Carlsbad jacket and pant and the Latitude jacket and pant all use a Gore-Tex Performance Shell with Gore-Tex's Guaranteed To Keep You Dry promise. They're CE AA rated, and each jacket zips to its pant.
  • Carlsbad for adventure riding. Klim built it as the light, fast, waterproof choice for adventure riders, with Rogue CE Level 2 armor and forearm, chest and back vents.
  • Latitude for long-distance touring. Now in its sixth generation, it's one of Klim's most popular touring pieces. It has a front zipper storm flap for wind and water and Rogue CE Level 1 armor (a Level 2 upgrade is available).
  • More Gore-Tex options. The Klim Badlands Pro A3, REV'IT Neptune 3 GTX and Dominator 3 GTX also use Gore-Tex shells or laminates.
  • Other waterproof, windproof membranes. The Alpinestars Cusco Drystar jacket has a removable Drystar layer that Alpinestars describes as waterproof and windproof.
  • A solid laminated touring suit. The Tourmaster Mariner jacket and laminated pants use a waterproof, breathable laminate shell, and the pants have a removable thermal liner.

Klim Carlsbad Gore-Tex adventure motorcycle jacket in Stealth Black

You'll find all of these in our rain jackets and pants, and the full cold-weather lineup in winter motorcycle gear.

Layer underneath the shell

Once the wind is handled, build warmth underneath in layers you can adjust:

  1. Base layer. Merino wool or synthetic, never cotton. It moves sweat away from your skin, so you don't get damp and cold at a fuel stop. More on choosing one below.
  2. Mid layer. A fleece like the Klim Inferno jacket adds warmth without much bulk, and it's comfortable off the bike too.
  3. Insulation or heat. This is where a puffy or a heated layer goes. In my experience, a puffy under a Gore-Tex shell gets you to about 45°F at highway speed. Below that, heat is what makes the difference.

Keep the stack snug but not tight. Insulation that's crushed under a too-small shell doesn't hold much warmth.

Picking a base layer: merino or synthetic

Both work. What matters is that the layer moves sweat off your skin, because damp skin plus highway wind gets cold fast. Pick the weight by how cold you'll ride.

Merino wool. We carry Minus33 100% merino in two weights:

Synthetic. Klim's Aggressor line is numbered by warmth: -1.0 is the cooling layer, and 1.0, 2.0 and 3.0 get warmer as the number goes up. We carry the whole range:

  • Aggressor -1.0 (cooling): long sleeve, short sleeve, pant and brief. Klim built these for cooling and wicking, so they're for warm days, not winter.
  • Aggressor 1.0 (warm): shirt and pant. It has a smooth next-to-skin finish and a low profile for minimum-bulk layering, so it's a good light layer for cool days or under heated gear.
  • Aggressor 2.0: shirt and pant. A gridded design traps heat while staying breathable and fast-drying. There's also the One-Piece 2.0, which Klim says eliminates the air gap between shirt and pant.
  • Aggressor 3.0: shirt and pant. Klim calls this its warmest men's base layer.

Klim Aggressor 2.0 synthetic motorcycle base layer shirt

Pick the weight the same way you would with merino: lighter for cool days, heavier for the coldest rides. For your feet, Klim's merino-blend Aggressor Sock 1.0 is its lighter-weight riding sock, and the Aggressor Sock 3.0 is its warmest.

When to add heated gear

If you're regularly riding below that 45°F line at highway speed, heated gear stops being a luxury. Start at your core. A heated layer under your shell, like the Macna Centre jacket, the Macna Cloud vest or the Tourmaster Synergy 12V liner, warms your chest and back, which helps keep your hands and feet warmer too.

Macna Centre heated motorcycle jacket, worn under a windproof shell

Heated gear still needs a windproof shell over it, or the wind carries the heat away. We cover power, batteries and what to buy first in heated motorcycle gear explained. Everything electric we carry is in heated gear.

Don't forget hands and feet

Hands usually quit first, and cold hands are a safety problem, not just a comfort one.

  • Block the wind. Hippo Hands handlebar covers mount over hand guards (Hippo recommends using them with guards), go on without tools, and come in three sizes: Backcountry, Rogue and Alcan. We're not carrying them this season, but you can get them from Hippo Hands directly.
  • Add heat. Macna heated grips warm your palms. The Macna Era 2.0 RTX heated glove kit warms the whole hand and comes with two 7.4V batteries and charging gear.
  • Stay dry. Waterproof gloves like the REV'IT Dominator 3 GTX gloves keep rain out.

For feet, start with a waterproof boot like the Sidi Adventure 2 Gore-Tex, add warm socks, and step up to Macna Lava 2.0 heated socks if your toes still go numb.

My advice if you only ride in the cold now and then

If winter riding for you is a couple of hours here and there, you don't need to buy everything at once. My advice is to figure out the temperatures you'll actually ride in first. Then start with a good waterproof shell, like the Mariner, and add heated gear over time as you find your limits. That way every piece you buy keeps working for you in the rain and in the shoulder seasons too.

Quick winter riding checklist

  • Know your temperature range and how much highway time you'll do
  • A windproof or Gore-Tex shell, jacket and pants
  • Merino or synthetic base layer, plus a fleece mid layer
  • A puffy or heated layer for colder rides
  • Hand covers, heated grips or heated gloves
  • Waterproof boots and warm or heated socks
  • A neck gaiter or balaclava to seal the collar

Planning to camp at the end of a cold ride? See our winter motorcycle camping checklist, and read how layering and sleep systems work at camp.

Pack small. Camp easy.

Frequently asked questions

At what temperature do I need heated gear on a motorcycle?

It depends on you and your speed, but I need heated gear when I ride highway speeds for more than about 30 minutes below 45°F. Slower riding on gravel or trails can stretch that range. Start with your own temperature range and add heat when your shell and layers stop keeping up. Browse our heated gear.

Is a Gore-Tex jacket warmer than a regular textile jacket?

A Gore-Tex or other windproof membrane isn't insulation by itself, but it stops wind and water from getting through, so the layers underneath can actually keep you warm. That gives it a real edge over a vented textile jacket with layers stacked underneath. Our go-to Gore-Tex suits are the Klim Carlsbad and Latitude. Even so, my Klim Gore-Tex gear with a puffy underneath topped out around 45°F at highway speed.

Can I just wear more layers instead of buying heated gear?

Up to a point. Layers under a windproof shell work well into the mid 40s for a lot of riders. Below about 45°F at 60 mph or faster, I haven't found a shell and mid-layer combination that keeps me warm, which is when heated gear earns its place.

What's the best way to keep my hands warm on a winter ride?

Get the wind off them first, then add heat. Handlebar covers like Hippo Hands block the wind at the bars (we're not carrying them this season, but you can get them from Hippo Hands directly), heated grips warm your palms, and heated gloves warm the whole hand. Many riders use a hand cover with grips or a lighter glove.